CONDITIONS OF ASSEMBLING AND USING
FOR CONVENTIONAL WORKING
Manufacturing tolerances of mounting socket D H7
Manufacturing tolerances of shaft dimensions Fkh6
Max out parallelism and linear slide bearings ±30'
Roughness of shaft surface Ra 0,32
Hardness of shaft surface min. 58 HRC
||Open slide bearings PLBO, opening angle γ= 60° and inside diameter ɸFk= 16; 20; 25; 30; 35 and 40mm, rest of parameters according to the table below.
||Part cut slide bearings PLBR, inside diameter ɸFk= 16; 20; 25; 30; 35 and 40mm, rest of parameters according to the table below.
Nominal life L10=(C/P)3 [5x104m]
L10 - nominal life, expressed as multiplicity of value 5x104m (50 km) the movement of shaft or slide bearing, or reciprocating travel. This is a life the correspond to 90% reliability, possible to achieve under the conventional working conditions, workmanships and used materials.
C - specific dynamic capacity of a bearings [N] is loading, that can be transmitted by slide bearings, with nominal life 5 x 104 m.
P - dynamic equivalent load of linear bearings [N]; this is a value of the force that is acting on linear bearings under the conventional working conditions.
DRAW A RIGHT SPECIFICATION